resistor remover

specter539 · Post by **specter539** » Wed Jun 20, 2007 7:23 pm

i accidentally hit resistor 93 off my snes board (ver 1) while i was desoldering the expansion slot. what should i do? i have no clue where the resistor went so i couldnt just solder it back on.

Post by **gannon** » Wed Jun 20, 2007 7:53 pm

Solder a 2.2K Ohm resistor in its place according to my schematic

specter539 · Post by **specter539** » Thu Jun 21, 2007 8:25 am

is there any good place where you type in the colors on your resistor and it spits out the ohms. i found one once, but forgot to bookmark it. Like i would need to inputthe colors orage, blue, green gold and it would spit out the rating of the resistor

Post by **gannon** » Thu Jun 21, 2007 5:04 pm

Google is your friend

http://www.dannyg.com/examples/res2/resistor.htm

specter539 · Post by **specter539** » Mon Jun 25, 2007 7:59 pm

bump. can i just use 2 resistors in a series? I have a a kohm one and a 1.2 kohm one. one is brown-red-red-gold and the other is brown-black-red-gold

Post by **gannon** » Mon Jun 25, 2007 8:14 pm

Sure, as long as they add up to the right value.

specter539 · Post by **specter539** » Tue Jun 26, 2007 2:52 pm

when looking at resistor 93 i believe that it is not even needed, because it is part of the expansion thing, and because i removed it, would it be ok to run the board with out R93?

Post by **gannon** » Tue Jun 26, 2007 3:46 pm

Try it and find out, I'd fix it though.