super joy III built in games to a NES or something blah blah

Thegamer3000 · Post by **Thegamer3000** » Thu May 10, 2007 1:28 pm

I have a broken Super Joy III and I wondered if I could wire the ROM chip to another NOAC... Okay I know I can do it but what I need is where the pins on the Chip go to on an american NES.

Kenny_McCormic · Post by **Kenny_McCormic** » Sat May 12, 2007 9:50 pm

if its a glob top dont bother but if its a cart then buy a converter

TheOnlyOneHeFears · Post by **TheOnlyOneHeFears** » Sun May 13, 2007 1:08 am

I'm not really sure what you're asking...you talk about another NOAC, then an American NES.
If we presume the ROM chip from the Super Joy III is a glop top, then it's pretty much impossible for both. Save the effort and buy another NOAC.

Thegamer3000 · Post by **Thegamer3000** » Tue May 15, 2007 6:05 pm

It's just a normal surface mounted IC like the one ontop of the forumns page... probably the same amount of pins too. All I wanted to do was wire it up to a broken cart slot so that I can play the games on a normal nintendo or the one I'm making (same thing)

Kenny_McCormic · Post by **Kenny_McCormic** » Thu May 17, 2007 2:47 pm

nope sorry cant be done unless your an engineer or something and if you were you wouldnt be asking us

Post by **gannon** » Thu May 17, 2007 3:16 pm

Does the NOAC have a cart port on it? If so you can at least trace the lines between it and the rom to get the pinout.

jeroen · Post by **jeroen** » Thu May 17, 2007 3:30 pm

Ya that way it would be possible. Or you could do it like Kevin Horton and un-pot it. but you'll prob damage the chip but you could find out what it is and get a pinout!

Klefmung · Post by **Klefmung** » Thu May 17, 2007 7:37 pm

or, you could enable the roms and wire the cart slot to another cart slot. it would play on the other one, but you would be using the noac as a whole for the roms.

Thegamer3000 · Post by **Thegamer3000** » Thu May 31, 2007 2:00 pm

Yah you guys are getting the idea. I know I could do it myself but I was wondering if someone already had it figured out.

First I'll have to trace each pin to the pin on a Japanese connector. Then figure out where those go on an American connector.... a lot of work and time which I don't think I really want to do. But I'll keep my broken Superjoy 3 for this reason anyways!