xbox 360 controller mod

Dilberitio · Post by **Dilberitio** » Tue May 22, 2007 2:14 pm

i know there's a section on spraypaint now but i have a quick question. If i sparaypainted an xbox 360 controller wold it still play well or would it feel all crappy? Thanks in advance, except for flamers, For them, hate in advance.

vskid · Post by **vskid** » Tue May 22, 2007 4:48 pm

It depends on what spraypaint you use and how good of a job you do. I spraypainted an N64 controller and it was all sticky and wore off. I'm pretty sure it had to do with the paint and I only used one layer. I think clearcoat usually clears up those problems.

ShockSlayer · Post by **ShockSlayer** » Tue May 22, 2007 5:00 pm

If you do it right, it pwnz.

Follow this method. All other methods SUCK!

Sand it down really good
Thin coat of primer
Very lightly sand excess primer
paint one layer slowly and 10 inches away

SS

bgnome · Post by **bgnome** » Tue May 22, 2007 5:05 pm

i saw some pics of a plastikote black that looked pretty good. you can try the ones that actually dye the plastic as opposed to paint.

Turbo Tax 1.0 · Post by **Turbo Tax 1.0** » Tue May 22, 2007 5:13 pm

vskid wrote:It depends on what spraypaint you use and how good of a job you do. I spraypainted an N64 controller and it was all sticky and wore off. I'm pretty sure it had to do with the paint and I only used one layer. I think clearcoat usually clears up those problems.

yup, when I painted my GC controller I used lots of thin layers and about 3 layers of clearcoat and it still plays like an ordinary controller

khaag · Post by **khaag** » Tue May 22, 2007 6:22 pm

Where's this "spraypaint section" ?

vskid · Post by **vskid** » Tue May 22, 2007 6:39 pm

khaag wrote:Where's this "spraypaint section" ?

Case Construction Sticky