Intec Screen Pinouts

cj_h4x0r · Post by **cj_h4x0r** » Wed Apr 11, 2007 9:38 pm

I have been looking all over the place for this, but can't seem to find it! I am looking for the pinouts for the intec screen pad main board, not the board with the controller. The main board has 8 leads!

Thanks,
h4x0r

loup · Post by **loup** » Thu Apr 12, 2007 9:22 am

this page has the pinouts if you have colored wires, and a link to the pinout if you have a grey ribbon cable

http://ladyada.net/make/gamegrrl/make.html

shmagoogin77 · Post by **shmagoogin77** » Thu Apr 12, 2007 4:59 pm

http://benheck.com/phpBB/viewtopic.php? ... c&start=15
check the post by me

cj_h4x0r · Post by **cj_h4x0r** » Thu Apr 12, 2007 5:43 pm

Those all have 7 wires, mine has 8. So which side would I start on? I'm kind of having a whole general problem with hooking the NOAC to the screen with a battery. I'm not completely electronics retarded but I just can't seem to get the idea right. Is there a diagram somewhere that has a view of where to connect what? Even a paint drawn diagram would be wonderful if it had a top view of colored wires!

Thanks,
h4x0r

shmagoogin77 · Post by **shmagoogin77** » Thu Apr 12, 2007 5:49 pm

what are the colors?

cj_h4x0r · Post by **cj_h4x0r** » Thu Apr 12, 2007 6:23 pm

Well heres the thing, I took out the ribbon cable it had a while ago, then I dropped the project for a while due to school. But now I am back, and don't remember which side the ribbon cable started on, well on the left side of the eight or the right side... It doesn't have any writing on it either.

In any case I have a question, on the wiring diagram on ladyada's site, there is no video in. Which one would I connect the video into?