New Problem!!! Wireless NOAC Pinouts!!!

[cj_h4x0r]

No need to waste a new thread practically, so heres my new problem!!!

I have been searching for the pinouts on the wireless version of the superjoy III. It is very similar, and all the pinouts are labeled, but I just don't understand all of them, most are no brainers!!!

There are three groups of outs:

Con0:
V-OUT|||Sound|||VCC|||GND
Con1:
GND|||VCC|||IR-OUT
Con2:
P2D4|||P2D3|||RES|||IR-OUT

Con0 and Con2 were connected to a separate circuit board with connections for the video and audio to the TV, the power out, and the connector for the light gun.

Con1 was connected to a another separated board that had leds and the ir eye for the wireless controller.

Now I got most of this down, the only problem is that I do not know which to connect the power to and the grounds to, and the video/audio, so mostly nothing... I'm guessing that I solder the wire for the video from the screen to Con0's V-OUT. Respectively to the sound wires. Then comes the power and ground. Do I connect the power and ground to Con0(which I tried but was unsuccessful) or to another Con?

help appreciated as always!!!
h4x0r