HELP

[Noobiebusters]

If you peeled off some a copper strip or two in the gerneral area of the IC chip on the left PC board, could you make an improvisation as lon as you make each connection go to its rightful place?

[figmentfilm]

if you can trace it back to a nice clear area (preferably an area where the trace is furthest from other traces) then you can scratch the trace, solder a small wire (magnet wrap wire or whatever) to two 'repair' areas of the leads... I recomend a very small dab of hot glue over each solder to keep it from flexing to a nice, clean, annoying break.
best of luck!
cheers!
Figment