DreamCast Vagrant

JackFrost22 · Post by **JackFrost22** » Sun Jan 23, 2005 11:57 am

As you may hav noticed both my snesp and my atarip are in disreapair. I have decided to consdtruct a DCp. I opened up one of them pretty small. I went into my junk bin and picked out some regulators and such.. I got it to run off of 14.4volts 2000mah. With a Psone screen. I dont think it will run too long thoguh. I'm probably gonna spring for a DVDp battery. I was gonna buy a case from Dave but he hasnt answered me yet. The amn thing its I want a cover for the laser. I dont have a case design yet but I want to use the original controllers with the hall effedct switches. I figured out that I am goning to have to extened the wires on the drive. My only problem is making the case. I need to vacum form or laser cut. I dont have either thoguh so I need a little help form you guys. How do I build the case?

JackFrost22 · Post by **JackFrost22** » Sun Jan 23, 2005 2:27 pm

Okay I looked in my phone book. Theres a laser engraving shop. My qouestion is how do i desing the case? Also what about the cover hm....

JackFrost22 · Post by **JackFrost22** » Thu Jan 27, 2005 6:24 pm

Okay I still haven't decided how I am going to build the case. I did figure out that I will use the official controller. I like it a lot more. I rewired the hall effect switches with guess what "Hall Effect switches"

. Yeah I know, but I did rewire the switches on the joystick with a PS joystick. I have the hall effect switches mounted on perf board right now, but I want to etch a new boad in the end. Why go through all this trouble?, you say. I HATE 3rd party controllers. They reak of poo. (Unless I make them

)

JackFrost22 · Post by **JackFrost22** » Fri Feb 04, 2005 7:07 pm

I need the gd ron drive pinouts.
Anyone have them

Dark Savant0 · Post by **Dark Savant0** » Fri Feb 18, 2005 4:33 pm

You would get more DC help at the dcemulation.com forum.

JackFrost22 · Post by **JackFrost22** » Fri Feb 18, 2005 8:23 pm

thanks