Super Joy 3

shmagoogin77 · Post by **shmagoogin77** » Mon Jan 22, 2007 5:20 pm

what shiould i try doing any help??

figmentfilm · Post by **figmentfilm** » Wed Jan 24, 2007 8:25 am

I have a mechajoyfuntime pad on order now. When I get it in I'll let you know, I'm hoping it's that annoying new revision for space reasons... if it is, I'll let you know what I find. I was looking at an older version last night and noticed a small cross of solder on the board... had a tiny piece of metal in it too... I desoldered it (it's dead from stress testing anyhow) and noticed it actually connected two copper pads on the board. I'de take a hard look at the board and see if you can't remember where that solder went. reconnect it and try.
Cheers.
Figment

shmagoogin77 · Post by **shmagoogin77** » Wed Jan 24, 2007 4:50 pm

i think i have the new board
i will post a pic of what the noac shows on the screen

Frostbyte · Post by **Frostbyte** » Thu Feb 08, 2007 7:22 am

Well, I'm going to start messing around with it now. I hope that I dont end up frying it. I'll try to help anybody out if I figure it out.

Frostbyte · Post by **Frostbyte** » Thu Feb 08, 2007 7:22 am

Well, I'm going to start messing around with it now. I hope that I dont end up frying it. I'll try to help anybody out if I figure it out.

figmentfilm · Post by **figmentfilm** » Sat Feb 10, 2007 10:03 pm

Anybody figure out the player 2 side? I tried tracing it back to the controllers.. . but the wire colors on the NOAC second player and lightgun don't seem to be right (2 blue wires... different pins).
Appreciate the help!
Cheers
Figment