Wiring Diagram

Rellizate · Post by **Rellizate** » Wed Dec 20, 2006 2:58 pm

Hey, I just made a diagram of how to wire you PlayStation, Playstation screen and battery together. Here it is:

What do you think?

dragon · Post by **dragon** » Wed Dec 20, 2006 3:18 pm

that should come in handy.

could you post a wireing dirgam for the playstation 1 scph-7002. i would appreice it because i am makeing a portable playstation 1 and i dont have the slim line model.

vskid · Post by **vskid** » Wed Dec 20, 2006 3:48 pm

dragon wrote:that should come in handy.

could you post a wireing dirgam for the playstation 1 scph-7002. i would appreice it because i am makeing a portable playstation 1 and i dont have the slim line model.

I think the big one is a ton harder to portablize. It has several voltages it needs, and its bigger.

dragon · Post by **dragon** » Wed Dec 20, 2006 4:08 pm

vskid said:
I think the big one is a ton harder to portablize. It has several voltages it needs, and its bigger.[/quote]

it is bigger but im not makeing it a handheld. its going to be a laptop stile portable. and my version has 5 cable not 7. can you tell me the pin out guide.

Rellizate · Post by **Rellizate** » Wed Dec 20, 2006 4:38 pm

Seriously, use a slim one. You can get them much cheaper, and there are tons of guides on the net for doing stuff to it.

dragon · Post by **dragon** » Thu Dec 21, 2006 12:41 pm

i would use the slim line verision if i could find one cheap enough.
but untill i find one i will try to work on this one.

p.s. does it matter if you dont have the disc in a sealed case.
i haqveit working of the mains but tthe disc is free spinning.

vskid · Post by **vskid** » Thu Dec 21, 2006 12:49 pm

Do you mean that the case is taken apart? Its fine to run it like that, just don't push the disc down into the laser or anything. Don't touch the board either, it could short from your sweat/oils on your hands.

dragon · Post by **dragon** » Thu Dec 21, 2006 1:00 pm

thanks. yea the case is totaly gone and and i have the motherboard mounted in th new case im useing. but the disc and the drive are just mounted on top of the board.