My NOACp Layout (New/Better Layout!!)

Super Cameraman · Post by **Super Cameraman** » Mon Jun 19, 2006 4:59 am

EDIT: Go down to the second version

Is this right?

-Super

XPCportables · Post by **XPCportables** » Mon Jun 19, 2006 6:52 am

are you doing no screen?

gamecube6 · Post by **gamecube6** » Mon Jun 19, 2006 7:21 am

*snicker*

madc0w · Post by **madc0w** » Mon Jun 19, 2006 7:59 am

Why is your battery conected to your video out... and nothing connected to audio... and no screen... and the nes controller hooked up to the power... Theres a lot of things wrong. The sticky at the top of the forum could seriously help you.

Super Cameraman · Post by **Super Cameraman** » Mon Jun 19, 2006 12:58 pm

Okay, I was in a mad rush when I made this thread SO:

I have no screen because I want to test out if I wired the controller right. This is the 13 pin version of the Super Joy III, and I did wire everything right, I just need to know if that's how a battery is wired, and if the battery is too powerful.

Please respond soon! I really want to start this.

-Super

bioniclebert · Post by **bioniclebert** » Mon Jun 19, 2006 2:10 pm

Noac needs 5V to operate, add a 7805.

Super Cameraman · Post by **Super Cameraman** » Mon Jun 19, 2006 2:15 pm

NEW VERSION!!

Hopefully this looks better.

What's going on in the diagram:

Since many things are going to pins 2 and 5 (power and ground) I want to solder wires to those pins, and the other wires that need to go to that pin are connected to the wires. (If that makes sense.)

For now, there is no screen because I really just want to know if my NOAC works, so I'm using a TV.

The AV ports are from the Super Joy III's controller board. (I'm not using the audio port because I have a headphone port.)

I'm using 4 AA's because that's what the Super Joy III was built to run on.

I know the red, yellow and orange wires for the controller are at the wrong place. Pretend they're one pin lower.

Thanks,
-Super