hahahah I almost got IT!

Krepticor · Post by **Krepticor** » Mon May 22, 2006 3:56 pm

ok here is my problem...

I got everything wired up....but when i flip the power....THE BLOODY SCREEN FLASHES ON AND OFF!!

there is no logo just a flashing screen HELP!!!!!

*EDIT*
ok I fixed that by cleaning up the solder joints, ends up I had some leftover flux, ironically now the N64 doesn't power up

Oh well lots and lots of debugging for me....

toby dawg · Post by **toby dawg** » Mon May 22, 2006 7:15 pm

try unsoldering the dc-dc and try the origional power brick

Krepticor · Post by **Krepticor** » Tue May 23, 2006 5:22 am

yea ends up the power wasn't hooked up right I think I may have finally fried my mobo in the video area

Krepticor · Post by **Krepticor** » Tue May 23, 2006 10:45 am

ok here's the thing I get a voltage from the video and audio lines so I know they are working...

I get the proper voltages from the power lines and the screen turns on

I am going to make sure the screen has everything attach on Its mobo but I think everything is hooked up correctly and is functioning (cuz if it was fried I wouldn't get a voltage from the video and audio would I?)

anyway I will be back after I check the screen tell me what you think...

*EDIT* the screen is good and hooked up right (cuz I haven't messed with it yet...)

anyway I have found the problem The n64 comes on but shorty after cuts off... what is happening? Do I not have enough ma? I have it plugged into the wall

I'll try without the incandescents plugged it...