Final assembly...

dajudge · Post by **dajudge** » Tue May 02, 2006 6:05 pm

I am putting a NESp together for the final assembly and was wondering if i would remove the metal shroud around the PSone screen of should i install it with the metal on...

thanks,
chris

Post by **Skyone** » Tue May 02, 2006 6:11 pm

What the hell? There's metal shielding on the PSOne screen? Are you talking about the metal bordering the actual LCD?

dajudge · Post by **dajudge** » Tue May 02, 2006 6:12 pm

that is correct... that actial metal around the LCD holding it to the light case....

Post by **Skyone** » Tue May 02, 2006 6:15 pm

Ya, leave it on. It's probably safer than having it off, and it doesn't take much room up.

demonofaj · Post by **demonofaj** » Tue May 02, 2006 6:15 pm

NOOO, that is the ground shielding, nevertheless it holds the light in place, do not take off that shielding, you can, but it'd be a LOT trickier from then on.

dajudge · Post by **dajudge** » Tue May 02, 2006 6:18 pm

thanks a lot guys/gals....

chris