Taking off the controller board

daleighan · Post by **daleighan** » Sat Apr 22, 2006 6:22 am

Does anybody know how I can connect the controller directly to the middle board on the Yobo nes so that I can take out the controller connection board?

Klefmung · Post by **Klefmung** » Sat Apr 22, 2006 10:03 am

There are a few letters next to each pin on the controller ports. There are also the same letters next to the holes where it is about to go to the main board. Desolder the controller ports and match holes with pins! Also, cutting off that board cuts off the +5v and the gnd. So short holes one and two, and short holes 6 and 7 if ya wanna input from the power/AV pcb. Which way the numbers start going up from is listed on the other pcb. Or you could just input +5v to hole 2 and gnd to hole 6 on the other pcb and forget what I just said AND the power/AV pcb. >_> Your choice.