soldering question

SpearMan74 · Post by **SpearMan74** » Sat Apr 15, 2006 8:38 am

Everywhere i look there are pictures of how a wire should look when soldered into a hole. I can't find what a wire soldered to, say a n64 cartrege pin, should look like. Does anyone have up close pictures of that? Or maybe wires soldered to wires? That would be a huge help.

vb_master · Post by **vb_master** » Sat Apr 15, 2006 8:39 am

Soldering 101 Episode 3.

SpearMan74 · Post by **SpearMan74** » Sat Apr 15, 2006 8:54 am

well when i practiced you could still see the defenition of the inside copper wire. Should it just be rounded, or is that ok?

SpearMan74 · Post by **SpearMan74** » Sat Apr 15, 2006 9:07 am

thanks a lot though. Well i meant that you can.....gosh i can't explain it....can see how the wire was twisted through the solder? I can't explain it....well you cleared most of it up. thanks again
Edit: Never mind. I looked at your picture closer and i can tell you did what i'm trying to explain.