Batteryz

EXE · Post by **EXE** » Sun Feb 12, 2006 8:05 pm

I was always confused between GROUND and Positive and negative leads
is negative a ground? because batteries have 2 wires and some diagrams have only 1 wire (or line) in them......I think....(uhh, mind hurts) can u guys clear this up for me and show how you can hook up a 7.2 battery to power the N64 and screen? (Psone screen)

daguuy · Post by **daguuy** » Sun Feb 12, 2006 8:10 pm

batteries have + and ground (0v), not negative. i'm not very good at explaining it other than that

EXE · Post by **EXE** » Sun Feb 12, 2006 8:25 pm

can someone pleeease show me a good diagram (that works) ???

Fanboy · Post by **Fanboy** » Sun Feb 12, 2006 8:27 pm

Check PoD. They have everything you'll need

.

daguuy · Post by **daguuy** » Sun Feb 12, 2006 8:30 pm

here's the power page so far of my new guide (it's under construction), it has what you need

EXE · Post by **EXE** » Sun Feb 12, 2006 8:38 pm

not familiar with POD....please show me

Fanboy · Post by **Fanboy** » Sun Feb 12, 2006 8:40 pm

portablesofdoom.org is where all the good info is. Click the "Systems" link on the sidebar and then click "Nintendo 64"

daguuy · Post by **daguuy** » Sun Feb 12, 2006 9:00 pm

that diagram is for a higher voltage interact screen. i'll have to submit my guide and all the up-to-date pinouts to POD when it's done

EXE · Post by **EXE** » Tue Feb 14, 2006 4:15 pm

P.S. I used a Verge screen (which is just a Psone screen inside a different case) and it is NOT wired the same as the sony version. Ill post a pic.....as soon as I figure out how

EXE · Post by **EXE** » Wed Feb 15, 2006 8:45 pm

Heres one:

EXE · Post by **EXE** » Wed Feb 15, 2006 8:54 pm

Heres where the power goes