Quick pinouts

Harshboy · Post by **Harshboy** » Sun Nov 27, 2005 10:54 pm

ok, i need pinouts for this:

nos_slived · Post by **nos_slived** » Sun Nov 27, 2005 11:53 pm

I would help if you said what it was...

Harshboy · Post by **Harshboy** » Mon Nov 28, 2005 12:05 am

its the official sony psone 5 in. lcd screen.....i just need the pinouts for composite( video, audio L and R ) and the grounds.......plz post asap! If your wondering, this is just the output and input board...i didn't scan the whole thing in

cennar · Post by **cennar** » Mon Nov 28, 2005 1:38 am

gamesx.com>AV pinout>Playstation>

Code: Select all

Pin     Name 	Description
1 	Gmd 	 Ground 
2 	Rt 	    Right Audio 
3 	Gnd 	  Ground 
4 	Lt 	    Left Audio 
5 	Y 	    S-Video Y
6 	Sync 	  NTSC Video/Composite Sync*
7 	C 	    S-Video C
8 	V-Gnd 	 Video Ground
9 	B 	    Blue
10 	+5v 	 +5 Volt
11 	R 	   Red 
12 	G 	   Green

Reaperman@home · Post by **Reaperman@home** » Mon Nov 28, 2005 1:39 am

why don't you forget that little board and find leads for them on the main screen board. they're labeled.

then I suppose you could trace them out, but there wouldn't be much point

Edit: nevermind, cennar's searching skills are legendary.

Harshboy · Post by **Harshboy** » Mon Nov 28, 2005 9:14 am

Well, my soldering skills arn't good enough to solder onto the bord, but these are easier by far.......so would this be right for composite? And for the plus5volts thing.....what do i do? Do i really need it for a NTSC psone screen...i've read that only PAL ones need the plus5volts.........anyway is this right?

Harshboy · Post by **Harshboy** » Mon Nov 28, 2005 7:04 pm

ok...can someone please tell me if the second pic is right, if not can you help me???????

cennar · Post by **cennar** » Mon Nov 28, 2005 7:34 pm

i hate you in some way i dont know why but your a vary eritating person, i just thought you sould know... but sure there corect.

teraflop122 · Post by **teraflop122** » Mon Nov 28, 2005 7:39 pm

cennar is spreading the christmas spirit!

Harshboy · Post by **Harshboy** » Mon Nov 28, 2005 7:55 pm

well screw you too

just kidding, thanks

Turbo Tax 1.0 · Post by **Turbo Tax 1.0** » Mon Nov 28, 2005 8:29 pm

in the future a multimeter would have helped you out just set it to the ohms symbol and use it to check for continuity

i know my explanation sucks go read the manual