benheck.com Forums

So can i just wire the 7+ of the n64 power supply to the pin on the N64?
Do i need to do anything with the ground of the N64 power supple?

So what do i do? Whenever i connect the N64 nothing turns on? I know i am getting 7.8 v from the power supply and 3.2 v from the PTH08080, but when i connect them all (like the diagram) i get nothing.

[*fixed] The pth08080 is giving out 5v how do i step it down more?

* Just added another resistor.

Even using the psone screen power adapter i get the same issue.

Thats how I wired it but wired like that nothing turns on. When all pieces of the n64 are disconnected the screen turns on.

I have the PDV 0700 battery giving at least 8 volts. When I do not connect the n64 the screen turns on and runs off the battery fine. But when I connect the 12+ and (3) negative terminals of the N64, the screen wont turn on. (3+ is not connected nor is the Ti chip wired to this in any way).

Did I ...

What are the three purple wires on the bottom right of the PSone Screen? Do they do anything and do I have to wire them like that?

Excerpt from *o*'s Harshboy Wiring Diagram

Where can I buy ribbon cable with a fitting that will go into the board and the actual cart plug?

What is the name of the cable/connector?

If I cant buy one, any suggestions for relocating the cart plug?

Ok, so would WAH work instead of the WAZ?

How do i know if it is lead free? Does that matter?

Really? Lol?

Thanks for your help!

So then why do they have different names?

Thanks jjhammerstein.

But how do i determine the pin layout? Specifically the WAH compared to the WAZ as I have the skyone WAZ schematic.

What is the difference between the :
PTH08080WAZ
PTH08080WAS
PTH08080WAH

Can I use any of them in my N64 portable with the Harshboy/Skyone schematic? Why or why not?

What is the difference between the PTH08080 WAZ, WAH, and WAS? Will they all work in for an N64 portable?