benheck.com Forums

Life of Brian, I can also cut the amount of the board off to make it fit correctly then sand the traces down a bit and then use wire solder them to relocate that part of the board, correct?

Just need a little advice on the correct and safest way to doctor the screens motherboard. I've seen a few cases which were cut and the wiring was then correctly reconnected to make the motherboard fit inside a zn-40 case. Some detailed instructions would be very helpful. Thanks.

I would really appreciate if someone could post/provide some images and instructions on dismantling an original n64 controller and wiring back to the main chip. When my custom case is constructed I want to place the buttons on opposite sides of the screen, and I'm not sure how to do this correctly ...