OH SH*T OH SH*T

shadowhacker · Post by **shadowhacker** » Sat Dec 10, 2005 5:13 pm

i just phoned into work when i found out i was fired... then i went back to work on my nesp and i was trying to remove the rfbox and in my hazy rage i just cut i out please say its fixible

minkster · Post by **minkster** » Sat Dec 10, 2005 7:03 pm

Hmm...it may live if u find the video, audio, and 5v traces and then connect them to a screen with ribbon cable. But I think it might be dead...try what you can though and tell us what happens.

mattb419 · Post by **mattb419** » Sat Dec 10, 2005 9:24 pm

I think minsker is right on this one... as long as you didn't cut off any of the little caps that were outside the RF box, then you should be okay. If you look at the board where you cut it, you should be able to see the traces, and scrape down to them.

-Matt

shadowhacker · Post by **shadowhacker** » Sun Dec 11, 2005 10:11 am

mattb419 wrote:I think minsker is right on this one... as long as you didn't cut off any of the little caps that were outside the RF box, then you should be okay. If you look at the board where you cut it, you should be able to see the traces, and scrape down to them.

-Matt

well ill look in to that then i didnt seperate any parts

benheck.com Forums

OH SHT OH SHT

OH SHT OH SHT