Xbox 360 Wifi Adapter Pinout

[thetwoj1014]

Hi all,

As you've heard a million times before, I've started on my own 360 laptop. Unfortunately, I'm having a hard time following Ben's instructions when it comes to the soldering of the new wires to the bottom of the mini-USB jack on the Network Adapter. As instructed I used a multimeter along with mini-USB jack pinouts I found online, but the unit refuses to work via my soldered connections (I know I haven't fried it because it still works normally with the standard USB to min-USB cable plugged in). Was wondering if anyone could give me a little guidance?

Thanks!

[mdh16]

i kno i kno your looking for the pins but you can just use the usb cord just scart it and hard wire it using a usb cable i had the same problem too .. and if you need a dxf file of the casing for the cnc machine hit me up because he released his drawings in pdf

[thetwoj1014]

I suppose I should clarify what I'm asking here. This is a picture of what I believe to be the correct pinout for the mini-USB port, if anyone could confirm/deny them that would be very helpful.

[thetwoj1014]

I figured it out! Here's the correct pinout just in case anyone comes up with the same problem

[mdh16]

AHH thank you so much i just now hard wired my wifi board