Because this is the case, I will not post a case WIP until the end, but will show the electronic goodness, somewhat like SS did on his 1st GCp.
In the planning/ ordering stages right now. Will be in a heavily modified white ZN-40.
When I'm done, I'll post the whole "Hailraiser style" WIP all on this page. Working on controls right now, as they're the only things I already own.
___________________________________________________________________________________________________
6/6/09
Just received my ti PTH08000 switching reg and wired it up. outputs the proper 3.3v, thanks to my 1.8k resistor that I bought on ebay.
PICS!
Top:
Bottom:
___________________________________________________________________________________________________
6/8/09
Found brackets that were perfect for the cart slot. The hole was drilled at the exact point where the cart would press up against the back of the case. pics follow.
Bracket
Attached
With Game
Side view
That's all for now.
___________________________________________________________________________________________________
6/12/09
Right control board wired, Left almost done.
Right:
With Buttons:
Left:
With Dpad:
Side:
Left still needs joystick, will wire it tomorrow.
___________________________________________________________________________________________________
