am i screwed-psone screen

Dilberitio · Post by **Dilberitio** » Wed Jun 13, 2007 2:08 pm

i pretty much destroyed slot one, can i just solder directly onto traces and pins or is that ill advised.

Kurt_ · Post by **Kurt_** » Wed Jun 13, 2007 3:06 pm

Dilberitio · Post by **Dilberitio** » Thu Jun 14, 2007 10:51 am

do you mean i am screwed or are not

timmeh87 · Post by **timmeh87** » Thu Jun 14, 2007 11:35 am

if its already totally screwed if you do nothing, how could you make it worse?

yeah you can solder to traces and pins (duh of course!) but be careful, cause one good yank on one of those wires can rip the whole trace right off the board.

Dilberitio · Post by **Dilberitio** » Thu Jun 14, 2007 3:20 pm

sweet.

bacteria · Post by **bacteria** » Sat Jun 16, 2007 4:05 pm

If you do solder to tracers or pins, and the joins are a bit precarious, you could hot-glue to the soldered joint to keep it in place. I had to do this with the GBA Transverter when I soldered to the microchip.

schmellyfart · Post by **schmellyfart** » Sat Jun 16, 2007 8:59 pm

the screen sticky wrote:To input composite video plus left and rght audio without using the mini av/in jack do this:

Yellow - Comp. video
Red - Right audio
White - Left audio
*Remember to tie the consoles and the screens grounds together!
Source: http://www.benheck.com/phpBB/viewtopic. ... 9&start=21