#1.Today i took off the on board switch, because i forgot i could just use the battery switch. So there are 8 total connections. I was wonderinf if anyone knew the order of connections id have to have to get the n64 to power up.
#2. Does anyone know that if i were to wire two 3A 7.2v batts in parallel and then splice one of the batteries in the parallel to the screen, would this short circuit?
3.3v goes to either pin 2,3, or 6. 7.2v goes to pin 7. (the numbrs are labeled on the mobo). just wire the screen and 12v line in parrallel and get something to get 3.3v and it'll work fine
no, im talking about the actual power switch thats mounted on the board. theres 2 squares of 4 pins each. i need to figure out which ones the bridge to get the n64 to turn on.
