PSOne Brightness & Volume buttons

damphool · Post by **damphool** » Mon Oct 03, 2005 9:19 pm

How odd is it that the brightness +/- buttons are a different height than the volume +/- buttons on the PSone screen? (anyone else notice this?) I still can't figure out why. Regardless, the taller ones are fine, but, the shorter ones just don't cut it. I have messed with them for a few hours (gluing various natures of spacers to the shorties) & I give up. In the book Ben talks about using 1/4" "nylon plugs" (holding them in place by gluing them to plastic backing). Any thoughts on this? Any other ideas?

demonofaj · Post by **demonofaj** » Tue Oct 04, 2005 10:40 am

Honestly, I don't know

Turbo Tax 1.0 · Post by **Turbo Tax 1.0** » Tue Oct 04, 2005 3:25 pm

yeah i noticed its a lot harder to make buttons for the brightness switches so i have to struggle with them on my snesp but its not that big of a deal

damphool · Post by **damphool** » Tue Oct 04, 2005 5:16 pm

The trouble is that when I ask for 1/4" nylon plugs, the staff at the hardware stores (at least the ones I have been to so far) look at me like I just asked for an albino smurf. Was just curious if anyone had found an alternative piece that was readily available. Guess I'll stay on the prowl.

daguuy · Post by **daguuy** » Tue Oct 04, 2005 5:19 pm

if you need an alternative but can't find one in a store, get a wooden dowl(or however it's spelled) and cut it to the right length

Turbo Tax 1.0 · Post by **Turbo Tax 1.0** » Tue Oct 04, 2005 5:22 pm

use k'nex they work and you can cut them to a good size plus they look good