My PSOne screen is diferent!

[davikf]

I get an original psone screen but it's diferent from de used un ben's book. There are two components in the place used to plug the resistor of the LEDS, so i don't know where to plug it. I need some help please.

Ignore the red circle. The components are those two gray little cylinder near the volume button.

[brunoip]

r u talking about the capacitors?

[davikf]

I think so...
Here is the ben's book picture:

[Mario]

You can put the resistor anywhere; it doesn't matter where it goes. Just wire it correctly and you'll be fine.

Also, don't use a 10ohm resistor. Use 100ohms.

[davikf]

Thanks Mario. The LED's are connected in series right? And I still use a 100ohms resistor if I use 4 LED's instead 3?

[marshallh]

That guide is wrong-if you do it according to that method you'll hurt the LEDs and they start flickering.


Put a 33ohm resistor in series with each LED. Then put 3/4 of those in parallel.

[davikf]

Hum... Ok, thanks. Other question, where is the ground in the PAL screen?

[Haunted360]

The Ground (Common Ground) on the Screen, is usually easily found where the Screw Posts are / went through.

It should be easy to see...