[Unknown]

[SonyPortableizer]

[Unknown]

[Haunted360]

Hey, well what you do (As this is what I did) was I got my Multimeter and set it to Ohms.

Now, here are the pinout sites I found

(I dont know if you wanted xbox 1 or xbox 360 because it is confusing but I did both for you)

XBOX - http://www.hardwarebook.info/Xbox_A/V
(Another) XBOX - http://www.gamesx.com/avpinouts/xbox.htm

XBOX 360 - http://www.llamma.com/xbox360/mods/Xbox ... Pinout.htm

And what you do is get a pin (Sewing needle) and then touch one of the wires while that is connected to the - or + of the multimeter.

While doing that, touch a pin (on the MoBo - Motherboard) and if you get a reading of 0.00 then you have a complete circuit. So write that pin down (as I do, on my table )

If not, try another pint until you do them all.


This is how I figured out the screen piouts for my PS2 Laptop - I also wrote it down and will so post it on my forums - so go and check them out! (See Signature)

If you cant do it, I will be willing to do it for you (IE: Commision) for $10. I will write all the pins down into a nice and organised table for you to be sent back (As I dont have a free Xbox 1 with me - Sold it . But I do have an Xbox 360 that is able to do this, so if this is for an Xbox 360, I can figure it out for you if you like)


Anyway, thanks and hope you figure it out

[vskid]

This is how I figured out the screen piouts for my PS2 Laptop - I also wrote it down and will so post it on my forums - so go and check them out! (See Signature)

If you cant do it, I will be willing to do it for you (IE: Commision) for $10. I will write all the pins down into a nice and organised table for you to be sent back (As I dont have a free Xbox 1 with me - Sold it . But I do have an Xbox 360 that is able to do this, so if this is for an Xbox 360, I can figure it out for you if you like)

Or, you could point him to a site like xboxscene, that actually has members and information.
http://forums.xbox-scene.com/index.php?showtopic=596642
http://forums.xbox-scene.com/index.php?showtopic=613160

[SonyPortableizer]

Thanks, right now I was about to ghetto solder the VGA port, but now I do not have to
Now just to be super cautious with the power supply

[Haunted360]

Yea, or you could do that...

[humakabula1]

you mean like this?

[SonyPortableizer]

Naw, I said I wanted one of the bored. I need simple pinouts, and ill screw up with that

[thetwoj1014]

The numbers on the diagram give above correspond directly to the numbered pins on the board. It's really not hard at all.

[vskid]

Naw, I said I wanted one of the bored. I need simple pinouts, and ill screw up with that

The first link in my previous post was of the pinouts at the board.

[humakabula1]

vskid has the "simplest" pinout