Wire Reccomendations?

[mebecj]

I've been planning out a project (it's not a portable, but I figure this community can still help me) involving a N64, and I'm wondering what types of wire I should use.

To explain a bit more, I'm wanting to put a N64 into a NES case. So basically I need to relocate everything that's attached to the motherboard. So I was wondering what types of wire I would need to relocate the controller slots, cartridge slot, Multi-out port, and power slot.

And, come to think of it, I'll need a way to wire the reset and power buttons to the NES's.

If anyone could help me out, I'd really appreciate it.

[snowpenguin]

Well, for power you should go with at least 20 AWG wire, but for anything else computer IDE ribbon cable does fine.

[Deck]

what can you use besides IDE ribbon cable?