broken traces after removing rom from radica genesis

[footinmouth]

hey guys, this might be unfixable but it just might be fixable. I managed to remove the rom from a radica genesis, however, 2 pins traces are broken, the broken pin traces are pins 24 and 34, are there any other places on the board that i could connect my wires for the cart slot on to make up for these broken traces? any help would be appreciated, thanks.

[footinmouth]

OH COME ON!!!!!!!!!

[chainfire95]

pics or it didn't happen

[footinmouth]

pics or it didn't happen

ok ok

[footinmouth]

pics or it didn't happen

ok ok

[chainfire95]

Buy a trace pen.

http://cgi.ebay.com/CIRCUIT-WRITER,-PAD ... dZViewItem" onclick="window.open(this.href);return false;

[footinmouth]

Buy a trace pen.

http://cgi.ebay.com/CIRCUIT-WRITER,-PAD ... dZViewItem" onclick="window.open(this.href);return false;

good thought, but i don't think that will work

[eagle5953]

Are you talking about the silver "external" traces? Because there are also "internal traces" that are gold and sit underneath the chip. Don't know if you need both sets of traces to get it to work or not.

Edit:

Looking at your picture, I'm still not sure about the gold traces that sit underneath the chip. You can see where they were on the board. Does anyone know if you can ignore them and just solder to the silver contacts?

[Skyone]

Pin 34 is obviously connected to ground, and pin 24 either to 25-32 or somewhere underneath the white silkscreen.

[footinmouth]

Pin 34 is obviously connected to ground, and pin 24 either to 25-32 or somewhere underneath the white silkscreen.

thx, ill have too use my trusty super bright desk lamp and some sand paper for that

[footinmouth]

Pin 34 is obviously connected to ground, and pin 24 either to 25-32 or somewhere underneath the white silkscreen.

thx, ill have too use my trusty super bright desk lamp and some sand paper for that

ill let you know how it goes

[neverused]

I'm not so sure 34 goes to ground. From what I can see, the trace goes off to the upper left hand corner. As for 24, you could just use the through hole after it, I think. I could be totally wrong though.

Ben's diagram shows 34 does not go to ground.

[footinmouth]

I'm not so sure 34 goes to ground. From what I can see, the trace goes off to the upper left hand corner. As for 24, you could just use the through hole after it, I think. I could be totally wrong though.

Ben's diagram shows 34 does not go to ground.

ok, 24 could be a bit tricky

[Skyone]

Oh, thanks for the correcting. Let us know how it goes.

[footinmouth]

.

ok i managed to find some using my trusty exacto knife, ill add some pics once my camera behaves