The cost of vacuum-forming...

Yes it is nice to be able to put your projects INSIDE something isn't it? You know, to hold everything together so it doesn't flop around? Discuss the techniques here!

Moderator: Moderators

Post Reply
pipakin
Posts: 22
Joined: Mon Sep 25, 2006 8:20 pm
Location: Tulsa, OK (middle of nowhere)
Contact:
Contact pipakin

Post by pipakin »

So did it work out for you? I know I'm looking into building a vac table soon and was wondering if anyone else had any success.

Also, since I know you're from the same area, where'd you go (or are planning to go to) for the plastic?
Bah!
Top
Life of Brian
Moderator
Posts: 2867
Joined: Wed Aug 03, 2005 5:55 pm
Location: Oklahoma
Contact:
Contact Life of Brian

Post by Life of Brian »

I haven't gotten a chance to do anything yet (stupid college - I go to school at UCO during the week). I hope to start working on it when fall break comes around, so hopefully I'll get to try it in a couple of weeks.
dragonhead wrote:sweet. ive spent a third of my life on benheck!
Image
Top
Turbo Tax 1.0
Portablizer Extraordinaire
Posts: 4773
Joined: Wed Mar 30, 2005 6:19 pm
Location: Delaware, no sales tax
Contact:
Contact Turbo Tax 1.0

Post by Turbo Tax 1.0 »

check out the sticky for plastic i posted a lonk in there awhile ago to some very inexpensive plastic
when life gives you lemons make flux
Image
snesp mk4
Top
pipakin
Posts: 22
Joined: Mon Sep 25, 2006 8:20 pm
Location: Tulsa, OK (middle of nowhere)
Contact:
Contact pipakin

Post by pipakin »

Well, got my bonus today, so I'm going to start putting together a vac table :-D

Wish me luck! :)
Bah!
Top
Post Reply

Return to “Case Construction”