benheck.com Forums

I love that demo of RE!


Great cases!

It stays at 1 when the 2 handles are together. I get readings from 50 to 200 to 35 from the pins. Some of the pins will stay at 1 when I hit 'em. I'm thinking those are the dead links. I'm on my lunch break now, but I'll mess with this thing more tonite.

Any other tips/hints/tricks would be cool ...

Kyo wrote:if it beeps, make sure it's not supposed to (it might be a short that is intended)

Mine has the selection on the dial you're refering to, but it dosent beep I dont have one that makes noise. What's a good and a bad reading look like?

So basically one point on the mobo and 1 on the cart slot on the corrosponding pin will give me a beep? Thanks again, and sorry these messages are short. Im posting from my iphone, at work.

Where do i put my pos and ground pins from the multimeter on the cart slot? Thankyou for the pic, also.

When doing a test with a milimeter where can i ground too?

The wise, What does?

It's in the right direction. I've re-wired it for the 6th time with some 22 guage wire to see if maybe the thicker wire would be better/easier. All wired up, and still no luck.

Here's some pic's

http://i50.tinypic.com/2ahzcet.jpg
Notice none of the conections are bridged.

http://i49.tinypic ...

Still no luck any suggestions on making my connecions more accurate?

Now when I flip the power switch, the 64 turns on fine without a game. When I put a game in the power supply buzzes and then shuts the 64 off...

Nope, the cart slot is the correct direction. But the thing is, is that it's a cart slot from a different 64. I dont think that'd make a difference. Not sure though. 3/4 of the way soldering for the 5th time. Lets see how it'll do.

So you're saying you bridged the inner holes with the outter holes and then from those 2 points went to the cart slot?

Sorry I'm just trying to troubleshoot any errors I may have made. I've resoldered this about 4 times already and I'm still stumped.

I have 3 different expansion packs, also.

Eagle, isnt the slot originaly put into the inside 2 rows of holes? All of my connections look good, looking at all my solder points with a magnifying glass nothing is touching and everything is soldered. I've tried 3 expansion packs so far letting the N64 "register them" for about 10 seconds each ...

That I could have fried my motherboard of my 64 just doing cart relocation? N64 powers on, led comes on, but no image on screen... The AV cables are good tested them with a good 64, also all my soldering looks good. I cant figure out why I cant get an image! :evil:

I did nothing to this mobo ...

No problem, now i gotta resolder and retest