Got my new NOAC yesterday/ some pics of my portable

schmellyfart · Post by **schmellyfart** » Mon Mar 13, 2006 2:35 pm

ok thank you. i still havent cut either the GBO board or the boeard with the glop top. so ill get to work and see how it goes

loup · Post by **loup** » Mon Mar 13, 2006 6:12 pm

one thing you can do is use a multimeter to figure out which traces are which on the GBO's controller. The little black pads on it are conductive, so if you scratch off the green protective coating over the traces you can use the multimeter to figure out which trace goes to which of the black pads.

schmellyfart · Post by **schmellyfart** » Tue Mar 14, 2006 12:07 am

i never would of thought of that! that will save me a lot of time! will i need to connect one side of each of the black pads to ground? or is there one ground wire already on there?

loup · Post by **loup** » Tue Mar 14, 2006 7:53 am

one side of the black pad will need to connect to the ground off the glop top. I believe that most of the grounded sides will still be connected together even after you cut the board apart, I think I needed to connect only two spots together on my GBO's controler for the ground

daleighan · Post by **daleighan** » Tue Mar 14, 2006 12:03 pm

That thing looks pretty sweet

schmellyfart · Post by **schmellyfart** » Sat Mar 18, 2006 9:16 pm

i finally figured out the controls on the glop top and GBO board! all i need to do now is figure out the ground(s) on the GBO board.