Nintendo 64 questions

nos_slived · Post by **nos_slived** » Fri Jul 22, 2005 1:03 am

 1  2  3
 O O  O
---------
 O O  O
 4  5  6

1. Charger positive
2. Battery positive
3. System positive

4. Charger negative
5. Battery negative
6. System negative

You can use a 4 section jack to play while charging the batteries. Just have 2 sections for DPDT pins 1 and 4, one section for 12VDC, and one for ground. Connect the last 2 to DPDT pins 3 and 6.

*o* · Post by ***o*** » Fri Jul 22, 2005 1:46 am

i was trying to figure out how to have it so when its charging i can also play the system.....but i figured it out (eventualy)

nos_slived · Post by **nos_slived** » Fri Jul 22, 2005 12:20 pm

Just make sure that you don't flip the switch(to the system side) when you have the plug in.

gamer2 · Post by **gamer2** » Fri Jul 22, 2005 1:26 pm

could i use an 8 pin switch to connect to the screen

Turbo Tax 1.0 · Post by **Turbo Tax 1.0** » Fri Jul 22, 2005 2:36 pm

if you just use one with 6 pins then it adiot proofs the charger so you dont fry the N64

*o* · Post by ***o*** » Fri Jul 22, 2005 4:07 pm

nos_slived wrote:Just make sure that you don't flip the switch(to the system side) when you have the plug in.

why?

nos_slived · Post by **nos_slived** » Fri Jul 22, 2005 4:58 pm

Because then instead of sending power from the batteries(pins 2 and 5) to the system(pins 3 and 6), you would be feeding power into the batteries(which is fine if it's power from a charger, but that would be power straight from a wall adaptor).

*o* · Post by ***o*** » Fri Jul 22, 2005 4:59 pm

ok...thanks nos!

gamer2 · Post by **gamer2** » Fri Jul 22, 2005 7:59 pm

Turbo Tax 1.0 wrote:if you just use one with 6 pins then it adiot proofs the charger so you dont fry the N64

where do i connect the screen to the switch?

daguuy · Post by **daguuy** » Fri Jul 22, 2005 8:00 pm

same as N64, they should be wired in parrallel

Turbo Tax 1.0 · Post by **Turbo Tax 1.0** » Fri Jul 22, 2005 8:11 pm

yeah just have two wires coming from the + to N64 then have ground come off the N64

gamer2 · Post by **gamer2** » Fri Jul 22, 2005 8:30 pm

coul i have 2 switches one for charging and one for power?

*o* · Post by ***o*** » Fri Jul 22, 2005 8:30 pm

how do i remove the power switch on the mobo i desoldered it and joined it the right way (i think) can someone suggest sometihng? and ill check if its the same way i did it..

*o* · Post by ***o*** » Fri Jul 22, 2005 8:34 pm

Code: Select all

  0                   0
               o-o     o-o
               o-o     o-o
           0                   0

0 where it attaches
o the actual switch connections
-bridge

gamer2 · Post by **gamer2** » Sat Jul 23, 2005 1:18 am

PICTURE

could somebody show where to connect the screen to the power switch?