PC or PS2 in DVD case?

*o* · Post by ***o*** » Fri May 27, 2005 3:52 am

that will be really cool

Goodwin · Post by **Goodwin** » Fri May 27, 2005 4:08 am

Quick question: On the back of the xbox power switch it has 4 pins each for both Power and Eject, I want to run wires from these to different switches the ones that were in the VCR so the buttons work the same.

The ones in the vcr only have 2 pins and not 4?!? does anyone know which ones to solder from?

If nobody knows I may make a thread in the xbox section to get a wider knowledge base on these switches.

Goodwin · Post by **Goodwin** » Wed Jun 01, 2005 3:29 am

sorted the above, just used the main pins on the connector of the switch.

Moving along nice now, even cut the hole for the screen to be fitted.

*o* · Post by ***o*** » Wed Jun 01, 2005 3:31 am

any pics yet?

Goodwin · Post by **Goodwin** » Mon Jun 06, 2005 1:53 am

no pics yet, just got my screen

Im having a problem with the power up of the xbox! it goes on then just off, not even a basic FRAG, might be the chip so I will take it off and test it as a standalone system.

Goodwin · Post by **Goodwin** » Tue Jun 07, 2005 1:33 am

I opened and pulled off the chip this morning, powered it up and it seems to be working but I didnt have any video cable plugged in so it was flashing orange (which is fine).

I will test later today and get some pics of it too, when I do I will start a new thread and stop hogging this one