composite to rf adapter

Kai · Post by **Kai** » Fri Jul 08, 2005 12:41 pm

Hi has some one used his leftovers of the 2600p used for a composite to rf adapter like ben?
I build it today and would like to ad sound to the rf signal does anyone know how???

THX

Kai

Post by **SpongeBuell** » Fri Jul 08, 2005 6:08 pm

Your best bet is probably to find the audio spot on the 4x4" board, and find where that connection goes on the modulator, keeping in mind what it goes through, such as transistors and resistors and capacitors (oh my!)

Post by **bicostp** » Fri Jul 08, 2005 6:13 pm

Where did you see this? I can't find it anywhere! (both this site and classicgaming.com/vcsp)

Post by **SpongeBuell** » Fri Jul 08, 2005 6:34 pm

it's in a very odd spot, the section where he talks about his MGDp

Post by **bicostp** » Fri Jul 08, 2005 6:42 pm

http://www.benheck.com/Games/MGD%20How.htm
^Somewhere in here? I've been over most of the website and I haven't seen this before...

EDIT: Nope, it's Here, on the old site. There's some good stuff on the old site, like the MGDp info and the old boards (and the old board's leopard, right B6?

)

Kai · Post by **Kai** » Sat Jul 09, 2005 9:29 am

It's some where in the MGDp stuff but I got a problem by now the VCSp I'm building woin't work perhaps its because of my board its Pal and different not like the NTSC I think I have to look up some schematic
if some one has done pal before please post the different steps in building
I think sound won't work on rf