PSONE controller split

demonofaj · Post by **demonofaj** » Fri Jul 08, 2005 6:34 pm

Sry guys if this has been posted before (the Search button brings crap results) anyways, how do you split a psone controller and re-wire it to work again. I mean like wat do you rewire after u split it.

*o* · Post by ***o*** » Fri Jul 08, 2005 6:35 pm

cut it where you want and rejoin the traces with wires

demonofaj · Post by **demonofaj** » Fri Jul 08, 2005 6:43 pm

which are?

soundwave · Post by **soundwave** » Fri Jul 08, 2005 6:47 pm

Traces. The light green things. Scrape the green off with a needle, works best.

*o* · Post by ***o*** » Fri Jul 08, 2005 8:06 pm

then add flux and solder

nos_slived · Post by **nos_slived** » Fri Jul 08, 2005 8:14 pm

Or lemon juice!

*o* · Post by ***o*** » Fri Jul 08, 2005 9:25 pm

Turbo Tax 1.0 · Post by **Turbo Tax 1.0** » Fri Jul 08, 2005 9:28 pm

lemon juice all around

mine actually has funky stuff forming on top o well

nos_slived · Post by **nos_slived** » Fri Jul 08, 2005 9:29 pm

LOL, your portable is rotting!

demonofaj · Post by **demonofaj** » Sat Jul 09, 2005 3:01 pm

Wait, correct me if im wrong,

but u guys mean, take the pin from lets say up on the d pad and take wire and solder the other end to 'up' on the IC chip?

Post by **bicostp** » Sat Jul 09, 2005 3:59 pm

On top is the PCB. Bottom is the finished part. Just cut the board in half and reconnect the broken traces with wire to make it work again. (of course donb't cut through IC's.

*o* · Post by ***o*** » Sat Jul 09, 2005 9:04 pm

great diagram dude

Post by **bicostp** » Sun Jul 10, 2005 8:28 am

Not bad for a 45 second Paint session.

But it gets the job done.

demonofaj · Post by **demonofaj** » Sun Jul 10, 2005 11:51 am

so i solder directly on the trace. Sounds crazy, but maybe crazy enough to work

, by the way im sry if i asked this before, what kind of wire would be good for this kind of job thanks.

daguuy · Post by **daguuy** » Sun Jul 10, 2005 12:01 pm

ribbon cable would be best