Peanutbutter, Intec Screens and Super Joy III= Portable

demonofaj · Post by **demonofaj** » Mon Mar 13, 2006 4:07 pm

I'm starting it, and will NOT show my PSONE -Rev 1.5 (yes it's negative) due to the fact it's a disgrace to everyone here. Anyways, I need some help here for my NOAC portable...I have an Intec Hip Gear like Screen (thank you Jeffslot), a Super Joy III (thank you machina28, also, it's a gray N64 controller with built in games with Super Joy written with the Roman Numeral 'III' italizized), and I have a 7.2 V battery...so would the INTEC screen run off of 7.2 V. and would 7.2V be too much for the NOAC to handle...it may not be able to stop the rock.

jedi knight · Post by **jedi knight** » Mon Mar 13, 2006 4:48 pm

Use a regulator. You can get them at radioshack for like $1.59. It will knock the voltage down so you won't fry your noac.

demonofaj · Post by **demonofaj** » Mon Mar 13, 2006 5:18 pm

Which regulator should I use, and the Intec Screen?

Harshboy · Post by **Harshboy** » Mon Mar 13, 2006 5:22 pm

i think you will need to buy or make a DC-DC regulator

demonofaj · Post by **demonofaj** » Mon Mar 13, 2006 5:26 pm

Waitaminute...I just checked the AC--->DC adapter that outputs 9 V., and there are four AA batteries for alternate power. Looks like anywhere between 6-9 V. is good, then gigity gigity gigity gigity gigity gigity good! But the Intec Screen Pad?

jeep · Post by **jeep** » Mon Mar 13, 2006 8:58 pm

a 7805 is your best bet. (for the NOAC). At least, it's what I use and I have no problem. Make sure you wire it correctly before testing though....

demonofaj · Post by **demonofaj** » Mon Mar 13, 2006 9:03 pm

OK...I'm off to Radio Shack...again

demonofaj · Post by **demonofaj** » Tue Mar 14, 2006 2:09 pm

Still the confusion of the freaking Intec Screen