N64p worklog

[JariV]

So I wanna buy this for the power:

2x Batterys
1x* PCB
1x* Fuel gauge

*do I need one PCB for the 2 batterys, or do I have to buy 2? And if I need to, w/ about the fuel gauge?

[JariV]

Bump, I need the answer for ordering the batterys..

[argelfraster]

You only need one PCB since the batteries are each 3.7v and the PCB is 7.4v.

[JariV]

Ok, thanks a lot! Really, a lot lot. Gonna PM Nevermind1534 now. He imports the batterys for me, since they charge $70 shipping to NL

Edit: were can I buy a charger for the Netherlands (you know, different plugs and stuff )

[argelfraster]

You'll have to buy a smart charger for the batteries, and get yourself an adapter.

[JariV]

You meen a US charger, and an adaptor for the Dutch plugs? I got that adaptor already I think.

[JariV]

So wait, I was going to order the ElCo and 2k Ohm resistor, but they only have 2,2 k Ohm and 1,65 k Ohm. Wich one to pick? D:

And if I already have the PTH08000, do I stille need the PT78HT233? And has anyone got a link to a smart charger for the batterys for NL plugs?

[JariV]

Bump? And will I be able to fit it in a ZN-40 case, or do I need 45?

[mako321]

it is very hard to do apparently, but it is possible to have a zn-40 n64.(it is very thin compared to the zn-45)

[JariV]

Ok, I'll just get 'em both
And still:

So wait, I was going to order the ElCo and 2k Ohm resistor, but they only have 2,2 k Ohm and 1,65 k Ohm. Wich one to pick? D:

And if I already have the PTH08000, do I stille need the PT78HT233? And has anyone got a link to a smart charger for the batterys w/ NL plugs?

[limpport]

With a ZN-45, you can get the expansion pack completely inside the case without having to relocate it. I'm not sure about the ZN-40.

[JariV]

But still this:

So wait, I was going to order the ElCo and 2k Ohm resistor, but they only have 2,2 k Ohm and 1,65 k Ohm. Wich one to pick? D:

And if I already have the PTH08000, do I still need the PT78HT233? And has anyone got a link to a smart charger for the batterys w/ NL plugs?

I really need an answer D:

[JariV]

Oh, and are 15000mcd LEDs good for the LED mod? fifteen THOUSAND! I ordered 'em 20 seconds ago

[JariV]

Since no one knew if I could use 2.2 kOhm, I just got 2 1 kOhm resistors. Still need to know this btw:

I ordere the PTH08000 sample from TI, do I still need the PT78HT233?
Is 15000 mcd good for the LED mod?
In wich device that everybody has but nobody uses is a 10 Ohm resistor? O forgot to order it and it would be stupid to pay 10 dollars shipping for it.

[JariV]

All questions answered, thnx.

So, gonna do the LED mod somewhere this week, new N64 should be in tomorrow. Batteries and ZN-40 probarly gonna be ordered this week.